Why is the heat not working in my Pontiac Montana?
Why is the heat not working in my Pontiac Montana?
If there is no power at the connector, the blower motor resister is bad. If there is power, the blower motor is bad. If the fan works OK but some or all positions of the level control do not work and the air cannot be controlled, one or more doors are not functioning properly. If one of the doors does not open, there will be no heat.
How much is a not working inspection on a Pontiac Montana?
Pontiac Montana Cruise control is not working Inspection at your home or office. Our certified mobile mechanics come to you 7 days a week between 7 AM and 9 PM. Our certified mobile mechanics can come to Chicago, IL now. Pontiac Montana Cruise control is not working Inspection costs $85 on average.
How do you adjust the seat back on a 2006 Montana SV6?
To adjust a seatback, pull up on the lever located on the outboard side of the driver’s or front passenger’s seats. Release the lever to lock the seatback where you want it. Push and pull on the seat to make sure it is locked into position. {CAUTION: If the seatback is not locked, it could move forward in a sudden stop or crash.
Who is the owner of the 2006 Montana SV6?
2006 Pontiac Montana SV6 Owner ManualM GENERAL MOTORS, GM, the GM Emblem, PONTIAC, the PONTIAC Emblem, and the name MONTANA are registered trademarks; and the name SV6 is a trademark of General Motors Corporation. This manual includes the latest information at the time it was printed.
Why is the up switch on my Pontiac Montana not working?
Doing the same test on the up switch with the blue wire did not work. So the switch’s down motion works, but the switch’s up motion does not work. Through several tests we found that the brown female wire was providing power, but the blue wire is not providing power and is not a good ground.
Why is my brake light not working on my Pontiac Montana?
It was a short in the rear light connector for the brake light / tail light / turn signal fixture. The GM supplier used a plastic connector that would not withstand the heat, so it started to melt, and the black power wire shorted out other wires.
Where does the motor go on a Pontiac Montana?
The motor has two male prongs…the down-motion male prong goes into the brown wire side of the female plug connector, the up-motion male prong goes into the blue wire side of the female plug connector. The motor sits in a plastic plug that does not have a ground.
What to do when left side light goes out on Pontiac Montana?
Use a small flat blade screw driver to clean the pin connection on the PC Board side. Go to the junk yard and cut out a couple of these wire harnesses for the plug. Cut off about 6″ of wire with the plug. Use a wire crimp tool to replace the plug. Be sure to wire it exactly as the one you remove. If you forget how, look at the left side light.
