Who do I call about a leaning power pole?

You can call 1-800-POWER-ON to report this so a technician can come out and evaluate the pole,” said Archie.

What should you do if you crash into a power pole?

If you hit a power pole, pad-mounted transformer (“green box”), or other electrical equipment, the correct responses in all instances are to stay in your vehicle or cab, and to call 9-1-1 and wait for utility crews to de-energize power (although there are several situations with additional instructions).

How long does it take to fix power pole?

How long does it take to replace a pole? Estimates vary greatly depending on the location and complexity of the replacement. General estimates range from 8 to 18 worker hours for a low-difficulty replacement and 20 to 75 worker hours for a high-difficulty replacement.

How far can a power pole lean?

Utility officials say even though you may see a pole that’s leaning it’s not necessarily unsafe. They say usually there’s about six feet more pole underneath the surface. It depends on the height of the pole but on average the poles that you see that Entergy owns they’re about six and a half feet.

Are electric pole transformers dangerous?

When they do, the transformer comes crashing down, potentially damaging property or hurting someone in the process. Dangerous voltage: Power lines strung between utility poles in urban areas are typically 4 to 25 kilovolts. Even at this lower voltage, touching a power line can causes severe injuries.

Will insurance pay if I hit a pole?

Your insurance will cover all of the damage to your vehicle (up to your limit,) minus your deductible. Usually the limit is the price of your vehicle, so as long as hitting a pole does not cost you more than the price of your vehicle, then your insurance will cover the amount.

What should I do before replacing my Power Pole?

Contact power pole before replacing anything. Excellent customer service. Take the remote box off and gently push on the potting in the back of it. If the potting pulls away from the edges of the box power pole will cover it under warranty.

How to troubleshoot a power pole remote box?

Please try again later. Take the remote box off and gently push on the potting in the back of it. If the potting pulls away from the edges of the box power pole will cover it under warranty. Contact power pole before replacing anything. Excellent customer service. Click to expand…

How many volts are on an electric pole?

What’s on an Electric Power Pole? Primary wires are on top of the pole and usually carry 12,000 volts of electricity from a substation. Insulators prevent energized wires from coming in contact with each other or the utility pole. Cutouts act like a fuse and open when there is a problem with the line or a section of it. A crossarm holds

What do the cutouts on a power pole do?

Cutouts act like a fuse and open when there is a problem with the line or a section of it. A crossarm holds the wires up on the pole. The neutral wire is below the transformer and acts as a line back to the substation and balances out the amount of electricity or load on the system. Lightning arrestors protect the pole and equipment

Why is my power pole not turning on?

I realized on the water my power pole didn’t engage when i pressed the the wireless remote. the LED light on the remote and deck remote show power with the LED turning on when keys are pressed. But the motor doesn’t turn on and also the LED on the power pole motor doesn’t lit up either..

How to troubleshoot no power and circuit breaker not tripped?

Verify the voltage is correct. No power at the connection terminal while the circuit breaker is in the On position indicates a defective circuit breaker. Remove the receptacle cover from the outlet without power. Check for voltage at the wire connection terminals on the side of the receptacle.