When does the parking brake alarm come on?

Rich. The alarm sounds while driving. Sometimes it starts immediately after putting the transmission in Drive (after releasing the brake). Most of the time it is activated / deactivated by bumps in the road. Any idea where that common ground would be?

Where is the parking brake light on a Freightliner?

I discovered that there is a Green Wire running from the front panel (under drivers window) to the rear panel (last bay on passenger side) that connects to a solenoid. It was barely holding on and came off when I pulled on it. I reattached it and tested the slides. They worked fine.

How does the brake warning light and buzzer work?

In addition to the brake warning light and buzzer, my driving lights turn off and on in unison with the brake warning light and buzzer. A new development is that my electric slide outs (2) seem to be acting up in that I sometimes have to move the ignition switch on and off a couple times to get them to work.

Why does my Kwikee alarm bell keep going off?

If it is bad it will also cause the “jacks down” alarm to sound. On the back of the Kwikee control board there is a 4 pin plug. If you unplug it, once your jacks are up, it will stop the alarm bell and light from being on. Mine used to be intermittent, but just in this past week it has been every time we retract.

I discovered that there is a Green Wire running from the front panel (under drivers window) to the rear panel (last bay on passenger side) that connects to a solenoid. It was barely holding on and came off when I pulled on it. I reattached it and tested the slides. They worked fine.

In addition to the brake warning light and buzzer, my driving lights turn off and on in unison with the brake warning light and buzzer. A new development is that my electric slide outs (2) seem to be acting up in that I sometimes have to move the ignition switch on and off a couple times to get them to work.

Rich. The alarm sounds while driving. Sometimes it starts immediately after putting the transmission in Drive (after releasing the brake). Most of the time it is activated / deactivated by bumps in the road. Any idea where that common ground would be?

Where is the low pressure switch on a Freightliner?

I have replace the Low Pressure Switch located beneath the Park Brake Release Knob. I have even bypassed the Low Pressure Switch by replacing it with an On/Off switch. The problem continues. I heard there is another type of switch located somewhere else.