What does green light mean on Atwood levelers?

Deborah, This is some information on an Atwood Electric leveling system. Might be close to your system. Look it over and let the group know if it looks like what is installed in you coach. Rich. Yes, that looks like the correct info. Page five states the red and green lights blinking indicate loss of power to the jack.

How do I Turn On my Atwood levelegs system?

1. Disconnect power to any jack by unplugging the jack quick connect wiring at the jack motor. 2. Turn power ON to keyboard by pressing the “ON” button. 3. Press “RET” and “ALL” buttons together to put system in error. 4. The buzzer should sound on the keypad and the jack lights should be blinking red and green. 5.

What happens if no current is detected after leveler is activated?

During any operation if no current is detected from leveler after leveler is activated, the following occurs: 1. Warning alarm will sound. 2. Power is removed from the control box disabling normal operations. 3. The red and green LED’s for that leveler will blink on and off to indicate the system is in an error mode. Solution: To proceed, 1.

How much does it cost to replace an Atwood leveler?

Had to lay and solder wires to the etches on the board. I have seal again. Atwood’s solution is a complete replacement of the whole system, jacks and electronics. When I can no longer repair, I will replace with HWH. My other two coaches with HWH never had a problem, but that is a $5,000 to $8,000 solution that I don’t want to do.

Deborah, This is some information on an Atwood Electric leveling system. Might be close to your system. Look it over and let the group know if it looks like what is installed in you coach. Rich. Yes, that looks like the correct info. Page five states the red and green lights blinking indicate loss of power to the jack.

1. Disconnect power to any jack by unplugging the jack quick connect wiring at the jack motor. 2. Turn power ON to keyboard by pressing the “ON” button. 3. Press “RET” and “ALL” buttons together to put system in error. 4. The buzzer should sound on the keypad and the jack lights should be blinking red and green. 5.

During any operation if no current is detected from leveler after leveler is activated, the following occurs: 1. Warning alarm will sound. 2. Power is removed from the control box disabling normal operations. 3. The red and green LED’s for that leveler will blink on and off to indicate the system is in an error mode. Solution: To proceed, 1.

Had to lay and solder wires to the etches on the board. I have seal again. Atwood’s solution is a complete replacement of the whole system, jacks and electronics. When I can no longer repair, I will replace with HWH. My other two coaches with HWH never had a problem, but that is a $5,000 to $8,000 solution that I don’t want to do.