How to reset atwood leveling system?

To proceed, the following is required:

1. Turn system on. This will shut the warning alarm off.
2. Visually inspect the leveler.
3. If it is required, activate levelers to correct problem. Simultaneously press the EXTEND or RETRACT mode.
4. Complete an ALL RETRACT operation and system is now.

What are the flashing lights on my Atwood levelegs?

Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.

How do you retract Jack on Atwood levelegs?

Manually extend slightly, then retract that jack by holding down the EXT key and pressing the two keys on each side of the lights, then RET plus the same two keys.

Why are the leveling jacks on my RV not working?

We’ve had a handful of members write in wondering what to do when the leveling jacks on their RV’s slide room, fifth wheel or tow trailer aren’t working properly. For most of these cases, their hydraulic system has either taken on a disturbing growling noise upon descension of the leveling jacks or they simply won’t retract back into the rig.

What should I do if my levelegs motor is not working?

If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning. They come off fairly easily when fully retracted. Obviously, you don’t want to be removing or even loosening them when they are extended and holding up the rig.

Periodically, especially if the rig has been sitting for a while, my Atwood Levelegs electric jacks will refuse to retract and will display flashing green and red lights, usually in one corner, indicating which jack is having trouble.

How to retract jacks on Atwood levelegs system?

Reconnect jack to power. Manually extend individual jacks for 10 seconds by holding down the EXT key and the two jack keys that make up the camper corner of that jack. Listen to insure all jacks move when manually activated. Press RET and ALL to retract all jacks. 2 RED AND GREEN LIGHTS COME ON FOR A SPECIFIC JACK LOCATION Cause:

What happens if no current is detected after leveler is activated?

During any operation if no current is detected from leveler after leveler is activated, the following occurs: 1. Warning alarm will sound. 2. Power is removed from the control box disabling normal operations. 3. The red and green LED’s for that leveler will blink on and off to indicate the system is in an error mode. Solution: To proceed, 1.

If this works and you can find a place that rebuilds electric motors, you could probably remove the offending jack and take it in for cleaning. They come off fairly easily when fully retracted. Obviously, you don’t want to be removing or even loosening them when they are extended and holding up the rig.