How many horsepower does a Ford 460 have?

Each makes over 400 hp and 530 TW. The combination of parts is also CALI emissions compliant !!! 26# injectors and an adjustable fuel pressure regulator help as do 255 lph fuel pumps. NO CUSTOM TUNE REQUIRED however one can tweek and tune for even better results.

What kind of engine does a F53 motorhome have?

F53 Motorhome Speciﬁcations Drive: 4×2 POWERTRAIN: Engine Application 50 States Type 6.8L Triton 3V V10 SEFI (gas engine, includes cooler) Transmission Type TorqShift HD 6-speed with Tow/Haul mode Speeds 6-speed Overdrive AXLES: Front Axle Type Forged I-beam Capacity (Rating @ Ground) 6500 and 7000 @16,000/18,000/20,500 GAWR; 8,000 @ 22,000 GAWR

What kind of transmission does a Ford truck have?

As of 2011 only transmission (manual or automatic) available in Ford Super Duty trucks. This transmission is the subject of a massive number of lawsuits alleging Ford lied in order to sell cars Ford knew had defective transmissions. 2013-present HF35 Hybrid and Plug in Hybrid transaxle.

What should the EFI be on a Ford 460?

Internal mods to 350 HP at which point the factory EFI is near its limit even with a chip and higher fuel pressure via an adjustable fuel pressure regulator. I recently did a motor home fuelie combo and the difference was night and day.

How much does a Ford 460 engine cost?

Ford 460ci 452 HP: from $6495 as a turnkey engine, depending upon parts used. Parts must be able to match HP application. Parts must be able to match HP application. — 460 ft/lbs torque

What was the firing order for the Ford 460?

Firing Order: 15426378 1973-1996 Ford 460 with 4 Barrel Carb Max Brake Horsepower: Both horsepower and torque for the 460 from 1973 until 1996 changed many times depending on emission controls, various fuel injection and carburetor setups as well as what the engine was used in.

What kind of cast iron does a Ford 460 use?

If you are looking for a stock OEM cast iron head for your 460 then the best you will find will be from a 1969 “C9VE” cast or a 1970 “DOVE” cast. The worst year for the factory heads of the 460 was 1972 due to a poor design of the quench area which is the area distance between the piston at top dead center and the flat surface of the cylinder head.

Max Brake Horsepower: Both horsepower and torque for the 460 from 1973 until 1996 changed many times depending on emission controls, various fuel injection and carburetor setups as well as what the engine was used in.

Where was the Ford 460 big block engine made?

These two engines proved to be the last of Ford’s V8 big block engines but are still quite popular today among engine enthusiasts. Beginning in 1968, the Ford 460 was manufactured at Ford’s plant in Lima, Ohio.

What should I do about my 1996 Ford 460?

Have the injectors cleaned by a pro (Involves hooking the fuel rail up and pushing a cleaning solution through them). Have the catalytic convertor checked out and replace the o2 sensor. Depending on the mileage, the engine itself is probably in good shape. It probably just needs gone over real good.

Where does the Ford 460 engine come from?

(I fully understand why you don’t want to get into it.) The 429/460 comes from the factory with an dismal flowing exhaust port that backs up quickly and kills engine power. Cleaning up the ports transforms the engine a la Jeckyl and Hyde.

How much horsepower does a Ford Z460 have?

And every Ford Performance Z460 engine is hand assembled in the U.S. with performance clearances. 575 Horsepower @ 5,500 RPM. 575 lb.-ft. Torque @ 4,700 RPM. Engine type: 351 based small block Ford. Displacement (cu in): 460. Bore x stroke (in): 4.150″ bore x 4.250″ stroke. Block: Boss 351 9.5″ deck.

What kind of head does a Ford 460 have?

The OEM heads on a 460 are a bit of a mixed bag when it comes to performance. The intake side of the head provides a cross-sectional oval port which helped give the engine the high torque ratings that it was known for.

What are the exhaust ports on a Ford 460?

The 429/460 comes from the factory with an dismal flowing exhaust port that backs up quickly and kills engine power. Cleaning up the ports transforms the engine a la Jeckyl and Hyde. In your case, it may help to install a freer flowing exhaast system, but this will help only so much as the exhaust ports will still be the primary restriction.

How big of an AC unit do I need for an RV?

The power of an RV A/C is measured in BTUs, and most units are going to offer 13,500 BTUs of output. That said, those who spend a large amount of time in places where the weather is hot will want to look into units with a higher output. Meanwhile, those who will rarely use their A/C may prefer something with less power at a lower price.

How many horsepower does a Ford 460 motorhome have?

I suggest decking the heads about .030″ and budget port work. Custom lunati voodoo cam on a 112 for the jet boat application. The C impellor will allow some 5800 rpm for about 450 HP so you will need to have the engines power band match.

What should the C / are be on a Ford 460?

A pair of small chamber heads will raise the c/r from the typical 7.7 to 1 to about 9 to 1 ish. This assumes the typical rebuilder dished pistons that are .030″ below deck. I suggest decking the heads about .030″ and budget port work.

Is the Ford 460 A J series engine?

Nor is that necessarily how Ford addressed certain matters when a production 460 was to be released as a J-series (Industrial/Marine) engine.

In 2000 the hp went up to 310. I’d have to say the bigger 460 had more power and torque than the newer V-10 it replaces. The biggest bad rap I’ve heard about the 460 is fuel pump inside the gas tank failing. The V-10 may suffer from the same fate but is still too new for this problem to appear.

Is the Ford 460 good for pulling a trailer?

Our 460 was fine when not pulling a trailer. But, since we do pull a trailer 99% of the time it did huff and puff on inclines. After having a Banks/Trans command system installed I have no problems. Made a huge difference. The engine clearly does not have to work as hard holding normal speeds.

What’s the timing set on a Ford 460?

I replaced our Half-Tooth-Retarded 460 timing set with a 429 set as described above. Only the crank sprocket is changed, but it gave the coach a lot of jump. We could pass most other large vehicles (tractor-trailers, diesel pushers) on steep uphills towing a car.

What’s the difference between a Ford 460 and V10?

Posted By:Krusty on 01/14/05 10:09pm 460 from 1994 had 245 hp and 400 ft/lbs torque compared to the v10 from 2000 had 310 hp and 425 ft/lbs torque. 99 v10 had 275 hp and 410 ft/lbs torque. Krusty 92 F-250 4×4 460 5spd 4.10LS Prodigy 97 Rustler RT190 EU2000i Garmin Posted By:delton on 02/20/06 07:43pm

What did I do to my 1992 Ford 460?

Just installed the Twisted smog box with all the smog elimination hardware on my 1992 F-250 460. I’m very satisfied with the power increase and difference in throttle response, more easily diagnosing the emissions garbage under the hood and allowing the engine to be more open was pretty liberating too.

What’s the bad side of a Ford 460?

On the bad side, however, the 460 head exhaust ports are extremely narrow and do not let the engine “exhale” to its full potential. The flow on the exhaust ports is so bad that adding a larger cam will completely choke out the engine and provide very poor performance at any RPM range.

What kind of engine does a 1989 Ford F350 have?

Versalift v029gs over rear axle mount bucket, 29′ max lift height, telescopic articulating one man bucket, utility body, spring type suspension, ford 7. 5l gasoline engine, 5 speed manual transmission, 137″ wheel base, 4,000 lb. Front axle, 11,000 lb. 1989 ford f350 for sale in fair overall condition.

How big is a coachmen Class A motorhome?

Originally constructing travel trailers and truck campers for the vacationing customer, Coachmen would soon add motorhomes to their product array. In recent years, the product assortment for Coachmen provides something for nearly all vacationers from simple deployable camping trailers to over 40-foot class A motorhomes.

What kind of engine does a 1989 Ford E350 have?

1989 ford: I ve got an 89 class b 24 motor home..chassis..mpg… I’ve got an 89 class… I’ve got an 89 class b 24′ motorhome on a 1989 ford e350 chassis with a 460 cu. in engine. It seems way underpowered and only gets 4-5 mpg.

What kind of truck is a 1989 Ford F350?

This is a very nice 1989 Ford Dually F350 For complete listing information please select the Click To Bid button to see this item on eBay. This Truck is a Solid and all around great truck. It has mostly been used as a weekend traveler, towing a 5th wheel travel trailer on long trips.

How to troubleshoot a Ford ignition module [ video ]?

Troubleshooting a Ford Ignition Module 1 Introduction. Ford used the TFI ignition module (thick film ignition) on vehicles from 1983 through the mid-1990s only. 2 Failure. The modules will fail once they have absorbed too much heat or for case problems. 3 Diagnosing the Module. …

What should the tming be on a Ford 460?

Tming; (A) replace a points distributor with a Duraspark unit that is recurved with a proper timing curve, (B) Set timing at 12* initial. 5. Both Crane and Harland Sharp offer roller rocker conversions; this is a great addition.

What kind of compression does a Ford 460 have?

Ford 460 with RV cam. 110-120 Psi. compression at 5000′ cold. Flowmaster Delta 50 2 x2.5″ in 1 x 3.00″ out. Stock Autolite Copper plugs. I am trusting Bob at Competition Carburation.

How many ignition modules are in a Ford?

Ignition Module, Replacement, Ignitor II® Kit 91281, Module Only, Each Ignition Module, 9-Pin, Ford, Laforza, Lincoln, Mercury, Merkur, Each Ignition Module, 6-Pin, Ford, Lincoln, Mercury, Each Ignition Module, OEM Replacement, Ford, Lincoln, Mercury, Each

What kind of ignition module does a 1993 Ford F150 have?

Applies to: 1992-1993 Ford F150. 1992-1993 Ford F250. 1992-1993 Ford F350. All of the information you need to diagnose a misfire or a no-start problem (caused by the ignition module or the ignition coil). Wiring diagram. Component pin outs. Connector pin outs. Firing order. Ignition system component parts numbers.

What are the specs of a 1985 coachmen motorhome?

MOTORHOMES – From 1995 to current, prices include 3-burner range, microwave, air conditioner, spare tire kit, tow hitch and awning. (**)These models also include VCP and driver’s door power window.

When did Forest River start making coachmen trailers?

In recent years, the product assortment for Coachmen provides something for nearly all vacationers from simple deployable camping trailers to over 40-foot class A motorhomes. Since 2008, Coachmen has existed as a division of Forest River Incorporated. CAMPING TRAILERS – 1995-current pricing includes furnace and awning.

What makes a Ford 460 a high failure item?

Four components can be / are high failure items on 460 equipped motorhomes. Exhaust manifold bolts, in-tank fuel pump, radiator, and E40D transmission.

What’s the life expectancy of a Ford 460?

Posted By: SieraSam on 10/28/04 10:21pm As you can surmise from all the answers on this thread, the Ford 460 of that vintage is a great engine except that in RV’s theey tend to suffer from the dreaded dual fuel pump problem. If one fails ( ususally in the fuel tank), the other will also fail.

Is the Ford 460 motorhome in good shape?

Depending on the mileage, the engine itself is probably in good shape. It probably just needs gone over real good. With proper care it should go 200,000 without any major problems. Be prepared to spend a few hundred dollars.