How does the pilot stay lit after the knob is released?

The button you press to light the pilot bypasses the thermocouple. When you release the button, the thermocouple ensures that unburned gas doesn’t get released by shutting off the gas when it’s not heated by the burning pilot light. Highly active question.

What kind of circuit board do I need for my Atwood water heater?

The quickest way to test a circuit board for your water heater is to use the circuit board from your Hydroflame furnace if you have one. The 8500 or 8900 models are the most compatible with your Atwood heater and should plug in easily. There will be the same 20-second delay that happens on your furnace when you power up the water heater.

How to test the Atwood water heater thermostat?

How to Test Atwood Water Heater Thermostat. The best way to test this part on your water heater is by using a continuity tester. When the water is cold there should be continuity between the contacts. When the water is hot there should be no continuity.

Why does my Atwood water heater not light up?

Atwood RV Water Heater Won’t Light When this happens to the GH6-6E Atwood water heater then the source of the problem could be the regulator or the thermostat or both. The solution t this problem, if these are the source, is to replace them.

Do you need anode rod for Atwood tank?

Because Atwood tanks are aluminum, they do not require an anode rod. So, depending on which one you have, remove the plug with the appropriate size socket wrench, with an extension, to make it easier to turn it out.