How do you realign a Schwintek slide?

The way to retime the Schwintek system is simple. You would go to the switch and depress the out button until the slide out fully extends. You would then depress the in button and bring the slide in 8 to 10 inches. We would then repeat this process a minimum of three times until the system fully retimes.

How does a schwintek slide work in an RV?

The slide is unique in that it uses some worm gears to make the slide out move in and out of the RV. There are motors to either side of the slide that help the slide move when you want it to move, and there’s a panel inside the RV that allows you to control the motor.

Why is my slide on my schwintek stuck?

I wanted to share my experience with my schwintek slide that was stuck open. When retracting the slide it would only move on one side. The other side would not even budge. The fault code on the controller showed it to be a shorted wire on motor #2. The override sequence at the controller did not work to retract the slide.

When to retime schwintek in wall slide out?

This happens when the two sides are not matching up when fully retracted or fully extended. Here are very simple instructions on how to retime your RV’s Schwintek In-Wall® Slide-Out if that occurs, as well as how you can prevent it from happening again in the future.

How old is my schwintek grand design slide out?

To start viewing messages, select the forum that you want to visit from the selection below. the bottom of my shwenteck slide out on a grand design reflection 27rl sticks out 3/4 in on the bottom on both sides when the slideout is fully retracted in. The unit is six months old and under warranty.

The slide is unique in that it uses some worm gears to make the slide out move in and out of the RV. There are motors to either side of the slide that help the slide move when you want it to move, and there’s a panel inside the RV that allows you to control the motor.

I wanted to share my experience with my schwintek slide that was stuck open. When retracting the slide it would only move on one side. The other side would not even budge. The fault code on the controller showed it to be a shorted wire on motor #2. The override sequence at the controller did not work to retract the slide.

This happens when the two sides are not matching up when fully retracted or fully extended. Here are very simple instructions on how to retime your RV’s Schwintek In-Wall® Slide-Out if that occurs, as well as how you can prevent it from happening again in the future.

What to do when your RV slide is not coming in?

RV Slide not Coming in (Retracting) When this situation takes place and before you move to the manual over ride system, check the control switch to see if it is working properly. Then check to see if you have enough power to the pump. If you do not get any power at the pump then you need to replace the switch.