The clutch cable and brake line can be measured similarly from their corresponding connection points. … When doing this, only measure the length of the housing; do not include the length of the free wire at each end. Subtract the length of your stock cable from the new measurement that you have made with the wire.

How are clutch cables measured?

The clutch cable and brake line can be measured similarly from their corresponding connection points. … When doing this, only measure the length of the housing; do not include the length of the free wire at each end. Subtract the length of your stock cable from the new measurement that you have made with the wire.

What size is throttle cable?

Inner Wire Diameter: The diameter of the inner wire, 1.2mm & 1.5mm commonly used for throttle and choke cables, and 2.0mm, 2.5mm, 3.0mm used on clutch and brake cables.

How wide are ape hangers?

Width Tip To Tip: 36″Knurl width: 1″ Center width: 15″ Knurl Spacing: 2-1/2″

How long is a stock Sportster throttle cable?

This throttle cable housing length is 28 1/2″ long. Fits 1996-2003 Harley Sportster XL1200S Sport models.

Are ape hangers illegal?

According to the biker, the cop just smugly told him that “ape hangers are illegal in California.” That’s not the law. … In other words, ape hangers cannot be more than six inches above the rider’s shoulders when he’s sitting on his motorcycle.

What is Teleflex Cable?

Teleflex. Flexible Cables are used for transmission of low voltage signals, while permanently connecting fixed parts of machine such as panel board to any apparatus or mobile units.

How do you measure throttle cable on a car?

Measure the distance between the throttle cable adjuster and the firewall fitting. Add 2″ to the measurement and mark the cable housing at that length. NOTE: The cable housing must not be straight between the throttle cable adjuster and the firewall.

Are ape hangers comfy?

Ape Hangers and Comfort Some people swear ape hangers are the most comfortable handlebars, others say exactly the opposite. For most, it depends on the bars. If you choose the highest, most extreme you can buy, you’ll get the pinnacle of in-your-face attitude, but your arms will go numb on road trips.

Are motorcycle clutch cables universal?

Yes you can… all the clutch cables have the same ends… they only vary in length… and you can get good used ones on ebay through Pinwall MC Salvage….

Article first time published on

Why do motorcycles have 2 throttle cables?

So why do some motorcycles have two throttle cables? The previous throttle grip arrangement of operating the spring loaded slide mechanism by a single pull cable was found to be inadequate. That’s why, dual or double cable system throttle grip system was invented to favor twin-cylinder motorcycles in particular.

How tight should clutch cable be?

A correctly adjusted clutch cable should have about 1/8” of free play measured at the pivot. When we have too much free play at the lever, the clutch is never fully engaged when we pull the clutch lever. This results in harder shifting and increased clutch wear.

How is brake line measured?

Look at the master cylinder where the lines are near each other to see if there are two sizes of tubing. You can also use a 1/4“ open end wrench to gauge your lines. It will fit easily onto 1/4″ line and will bang back and forth on 3/16″ line.

What is a push pull cable?

A push/pull throttle cable is an upgrade to the old standard single throttle cable linkage. The throttle grip works on the carburettors when twisting/throttling up and when releasing/throttling down. This is a step up to the single throttle cable type where only a spring is responsible for throttling down.

Are boat throttle cables universal?

Replacement throttle control cables are generally an OEM or 3300/33C Universal type. Teleflex Marine control cables meet OEM specifications for fit, function, reliability and quality.

How long has Teleflex been in business?

History. Teleflex was founded in 1943. Over time the business expanded into a conglomerate operating in multiple markets, often through acquisitions, such as: Franklin Medical Ltd (1985)

Who invented the Bowden cable?

The Bowden mechanism was invented by Irishman Ernest Monnington Bowden (1860 to April 3, 1904) of 35 Bedford Place, London, W.C. The first patent was granted in 1896 (English Patent 25,325 and U.S. Pat.

Are ape hangers harder to control?

Thus, ape hangers move hands not just higher, but also closer. If the hands become too close to the chest, it can be hard to control a bike. … Ultimately, the bike handles exactly the same as it did with different bars — but if the handlebars aren’t right for a rider-and-bike combination, the handling may feel awful.

What size apes should I get?

In general, your hands will be most comfortable at some height below your shoulders, with hands spread slightly wider than shoulder width. Run a tape measure down from one hand to the height of the risers on your bike to get an approximate height that you find comfortable.