How do I reset my Fisher Paykel DishDrawer?

How do I reset my Fisher Paykel Dishdrawer?

1. Press and hold the button decorated with the key and lock image for five seconds.
2. Press the power button to turn off power to the Fisher & Paykel dishwasher.
3. Wait a few minutes and then press the power button to restore power.

What does F1 mean on my bush dishwasher?

F1 indicates water has leaked in the base of appliance and activated the anti-flood device. You will have to unplug the appliance and pull it out. Then tip it backwards by around 45 degrees so excess water drains off completely.

What does F1 mean on a Fisher and Paykel dishwasher?

The company calls them DishDrawers instead of dishwashers. The F1 fault code indicates that water has filled the flood pan beneath the bottom drawer of the machine. This can happen if the drawer isn’t shut all the way, something tall prevents the unit from sealing properly during washing or the actuators have failed.

What are the fault codes for A DishDrawer?

DishDrawer™ ‘F’ Fault Codes Fault Code Possible Cause F1 Flood Detected You will require a Servic F2 Motor Rotor Fault There may be debris or F3 Temperature Fault You may need to have a F4 Heating Element Failed You will require

What to do if your dishwasher has an F fault code?

If the display is showing an F fault code, you may be able to clear the fault by resetting the dishwasher – see the steps below. If the fault persists, note down the code before disconnecting the dishwasher from the water and power supplies and Contact Customer Care. Press to stop the beeping.

What is the error code on a Fisher dishwasher?

NOTE: Some error codes for Newer Fisher And Paykel dishdrawer dishwasher models will be displayed as a digital code in an LED or LCD panel or display on the front of the dishwasher. Error Code Cause: Flood switch is activated. How To Fix: Turn the water and power supply to the DishDrawer off. Check Flood Switch. Error Code Cause: Motor Issue.

What does the F1 code mean on a dishwasher?

Hi there and welcome to JA, The F1 fault code means that water is in the base pan of the dishwasher. (Flood switch) Unplug the machine from the power point.

Why is my DishDrawer displaying an F1 error?

Hi All. I have a Fisher and Paykel Dishdrawer which is displaying an F1 Service Error, the manual says this is the internal flood code, the unit is hardwired and i cannot just turn it off at the mains without killing power that that entire circuit in the house.

How to troubleshoot an F1 error in a Fisher and Paykel dishwasher?

Troubleshooting an F1 Error in a Fisher & Paykel Dishwasher Step 1. Locate the drain-access filter panel on the bottom of the drawer. Step 2. Remove the rack that sits above it. Step 3. Pull up to lift the drain filter and remove it from the machine. Step 4. Set the filter under the faucet to