Determine the slope of ground between the two ponds you wish to connect. … Siphon off some of the water in each established pond using a garden hose or wet-dry vacuum. … Cut rigid pond liner in the two ponds down to the depth of the trench you dug.

How do you link two ponds together?

Take a piece of pre-cut pond liner at least wide enough for the channel width plus twice the depth + 10%. Make sure the liner is LDPE or rubber and it can be joined to the existing pond onto the channel cut by using cold glue joining tape. It makes a nice looking effect for one pond to spill over into the other.

Can you put 2 pond liners together?

Can you join pond liners together? The simple answer to this is yes, for the most part! Almost all pond liners are already joined together from smaller widths, either by us or at the manufacturer’s factory.

How do I make my existing pond bigger?

1. Remove any plants and fish from the pond to keep them safe while you remove material from the pond bed.
2. Drag the back of a metal rake slowly along the bottom of the pond. …
3. Dig into the edges of the pond as needed, expanding the sides of the pond outward.

How much should a pond liner overlap?

Remember to factor in extra for the lip to anchor the liner over the edge of your pond – at least 2 feet/0.15m overlap to go around the entire rim of your pond.

How do you use cold glue tape?

1. The tape is double sided and can be used on either side.
2. Leave the tape attached to the wax backing tape and cut to size.
3. Once in place remove the backing paper.
4. Press a patch of liner or the liner that is to be joined into the tape, or leave to harden without patch. Leave for 24 hours to harden.

How do you add a bog to an existing pond?

1. Select a site for the bog at the edge of the pond. …
2. Excavate the bog area to a depth of 2 feet 3 inches below soil level. …
3. Line the bog with 2 inches of sand. …
4. Fill the bottom of the bog with 1- to 1 1/2-inch round gravel to a depth of 6 inches.

How much does it cost to dig a pond?

Cost to Build a Pond The average price to install a pond ranges from $1,242 and $5,469, with most homeowners paying around $3,355. The expense for a small project is usually $2.50 to $7.15 per square foot. For a larger-scale project (up to 10 acres), expect to pay $3,000 to $8,200 per acre or more.

What size excavator Do I need to dig a pond?

Excavators vary in size and strength depending on what they will be used for. If you intend to dig a small personal pond, a compact excavator is the best variety for the job. If your project requires a depth of more than 14 feet, however, you may want to opt for a standard excavator.

How do you dredge a pond?

1. Creating a channel for draining your pond, if called for.
2. Using an appropriate-sized dredge boat to remove the built-up sediment layers.
3. Refilling the pond via the constructed channel or allowing it to refill through rainwater.

Article first time published on

Can you seam pond liner?

Joining EPDM rubber pond liner may seem like a difficult task, but with some planning and patience you can join two pond liners together with a leak-free seam quite easily. … Apply quick prime or quick prime spray adhesive to the seam area on both pieces of liner and allow to dry, usually about 10 minutes.

What do you put on top of a pond liner?

Adding cement, mortar, or concrete over the top of a pond liner will add strength and durability to the pond liner. Adding that extra layer over the top of the plastic will also allow you to use a broader variety of decorations and plants.

How do I hide the edges of my pond liner?

Flagstones or field stones provide the simplest method of hiding a pond liner. Simply create a flat shelf of soil about 8 to 12 inches below the intended surface of the pond, then install the liner over it. You can stack flat stones on the shelf to hide the liner and keep it in place.

How deep must a koi pond be?

Generally, the ideal size for a Koi pond is considered to be over 1,000 gallons and at least three feet deep. Size: Koi fish need a lot of space.

How often should I add beneficial bacteria to my pond?

We recommend using this dissolvable bacteria in your pond on a weekly basis to ensure optimal water quality and clarity throughout most of the year. Add this beneficial bacteria to your pond WEEKLY even when your pond looks it’s best.

How deep should you dig a koi pond?

A serious koi pond should be at least 3 feet deep and no areas should be shallower than 2 feet. Any areas shallower than 2 feet is an open invitation to dinner for both blue herons and raccoons. If you don’t think you have predators in your neighborhood just build a shallow pond and watch what happens!

How do you build a bog garden next to a pond?

1. Fill with topsoil and humus rich garden compost if it is a moist area .
2. Fill with aquatic compost or a clay/loam mix if it is a wet area .
3. Do not use multi purpose compost for a wet ‘bog garden’ as this contains peat.
4. Cut the liner off at the top of the hole so the area can blend into the rest of the garden.

How do you build a bog garden on the edge of a pond?

1. Pick a spot. …
2. Dig a hole. …
3. Lay a butyl liner in the hole. …
4. Water the soil thoroughly. …
5. Leave the soil to settle for about a week before planting up.

How do you edge a pond with bricks?

Bricks. A row of bricks around the pond also makes a nice edge. You can lay the bricks around the entire edge of the pond or build a small brick wall at one end where you can place some pot plants or create a wall fountain to enhance the look of your pond.

What glue can I use in a pond?

Black waterfall foam is a polyurethane product similar to insulation foam and meets all the characteristics of a suitable adhesive for attaching rocks to a pond liner. Besides being strong, non-toxic and waterproof, it expands to fill wide gaps between rocks.

Can you patch pond liners?

A more DIY version of fixing your pond liner is to use a patch of pond liner and some pond sealant. … All you’ll need to do is purchase the sealant and a patch of pond liner. Put a bead of sealant all around the edge of the patch and then place it over the hole.

Can you build a pond with a backhoe?

A pond is a picturesque feature that can add value to both residential and commercial sites. The best way to dig a pond is to use an efficient backhoe rental. This equipment will help you dig quickly and accurately, so you can create a stunning pond area with minimal effort.

Can I dig my own pond?

Both practical and idyllic, farm ponds are a dream for many newbie farmers. … There is much more to building a pond than digging a hole and letting it fill. If you don’t have a background in engineering, you’re going to need outside help to make it happen.

How deep should a man made pond be?

Having most of a ponds depth between 10-12 feet is ideal. The ideal average water depth is 8 feet.

Does a pond increase property value?

Ponds provide recreational opportunities, increase property values. Many people enjoy living near a body of water. … Lutz noted that studies have found that in rural areas, a well-managed pond can increase property values five to 15 percent.

How often do ponds need to be dredged?

A general rule of thumb is that storm-water ponds should be renovated every 15-20 years. However, urban development within the watershed may expedite the need for attention.

When should I dredge my pond?

Late autumn is the most practical time to de-silt a pond and will have the least disturbance on the wildlife. Small ponds can be dredged by hand, but do not remove more than half of the silt in any one year. Many animals eggs and larvae will be within it and the silt remaining will allow the pond to restock itself.

Should I dredge my garden pond?

Pond dredging sometimes becomes necessary when pond depth becomes too shallow for the pond to be self-sustaining. … In this event, your pond becomes a cesspool full of algae and unpleasant odors. Don’t bother looking for wildlife or fish, because they won’t be able to survive.

Can I put a new pond liner over an old one?

It’s best to remove old and damaged liners before adding new layers, but it is possible in some cases to just place down a new liner over the old one. You’ll need to remove everything that’s in the pond first, including any rooted plants and sand or gravel spread over the bottom.

What is pond sealer?

Pond Sealer is a flexible water based membrane used for waterproofing ponds and water features. Being UV stable, Pond Sealer is suitable for use both internally and externally and is safe for all aquatic life.

What is EPDM tape?

The EPDM tape is a multi purpose seal that can also be used as a compression seal in casement windows and doors. Our 4mm thick option is designed for use with the EasyClip Dry Glazing Security System. Available in 3mm, 4mm & 5mm thickness. Compress by 25% for an optimum seal.