You will need a drill and drill bit, stud finder and level to hang them. If your rods or curtains are particularly heavy — or if you have to secure them to drywall — you may want wall anchors as well. You’ll also need a tape measure, pencil, ladder and, of course, your curtains.

Can you put up a curtain pole without a drill?

You can use adhesive hooks or a tension rod to hang up curtains without a drill.

How can I hang curtains without putting holes in the wall?

1. Use Temporary Command Hooks.
2. Hang Curtains With Tension Rods.
3. Order Custom Compression Shades.
4. Make a Faux Roman Shade.
5. Buy Twist & Fit Curtain Rods.
6. Suspend Curtain Rods from the Ceiling.

What tools do you need to put up a curtain pole?

Tools needed to fit curtain poles Power drill, with hammer capability; drill bits; masonry for brick etc; titanium for steel lintels; wall plugs and screws; spirit level; screwdrivers; pencil for marking up; saw, pipe cutter & mitre block. If you want to be hi-tech a laser level is helpful too.

Will no more nails hold a curtain pole?

Re: DOES NO MORE NAILS REALLY WORK? DA. No More Nails is not bad but there is no glue in the world that will stick up curtain poles because the substrate will give even if the glue doesn’t.

How much should a curtain pole overhang?

For a typical window without architraves, we recommend poles/tracks overhang the width of the window by not less than 15cm (6″) each side (excluding finials). Mark the pole/track and check your measurements again.

Do you need a wooden batten for a curtain pole?

Usually no need for battens if you have a skilled curtain fitter using the correct fittings and a quality pole, even with heavy weight fabric and interlining.

Can you hang curtains in drywall?

Hanging curtains on drywall is not as simple as it looks. Drywall will not hold a screw because it’s not solid. If you mount a curtain rod with a screw, over time you will end up with a sagging curtain and hole. Using drywall anchors is the only solution.

How do you hang patio curtains without drilling?

If you want to hang outdoor curtains without drilling holes, tension rods are the way to go. This method is especially helpful for patios with columns made of stone or brick. You can also use ceiling-mounted hardware for brick or stone patio walls.

Can you hang curtains with Command hooks?

Be sure to wait the required hour to allow the adhesive to bond before hanging your curtains. You can see how wonderful hanging curtains with command hooks worked out! We lived in this home for two years and the command hooks held the curtains the entire time with no issue!

Article first time published on

How do you hang curtains over horizontal blinds without drilling?

Another no-drill method you can use for hanging curtains over blinds in your room is by using Velcro. Here, you’ll fix one side of the Velcro to the inside of your cornice or headrail bar (if yours has got space for it). Then attach your curtains to the other side and it’ll fit nicely.

How do you hang a curtain rod without studs?

If there isn’t a stud, you need to use a drywall anchor and a screw to reinforce your curtain rod brackets. Without a drywall anchor, a screw won’t be able to hold the weight of your curtain rod. You risk pulling the brackets out of the wall and causing further wall damage.

What is wooden batten?

batten, term used in joinery for a board 4 to 7 inches (10 to 17.8 cm) wide and not more than 3 inches (7.6 cm) thick employed for various purposes. In sailing the word is applied to a strip of wood nailed to a mast to prevent rubbing or to fix down a tarpaulin over a hatchway in rough weather.

How high do you put a curtain pole above the window?

DO Hang High The higher the curtain rod, the taller the window will appear, so fix your curtain rod closer to the ceiling than the top of your window, if you can. One rule of thumb is that they should sit 4-6 inches above the window frame.

How big should my curtain pole be?

We recommend that the track or pole sits 15-20cm above your window, and be wider than your window by 15-20cm on either side. If you have a track or pole already fitted, ensure you measure the full length.

How thick should curtain rod be?

Choose a curtain rod with a diameter of at least 1 inch (2.5 cm). Thin curtain rods tend to look cheap and can bow under the weight of your drapes if they are heavy. When choosing a curtain rod, look for a rod that is at least 1 inch (2.5 cm) thick for good aesthetics and curtain support.

Should my curtains touch the floor?

Yes, curtains should be long enough to touch the floor. With a few exceptions, the longer the curtains are the more stylish and elegant it will look. This is why most standard ready-made curtains are lengthy. But the reality is that various decorating styles use different curtain lengths.

How do you hang curtains outside without a rod?

Hanging Outdoor Curtains without Curtain Rods If this is the case for your patio, consider using heavy-gauge exterior steel wire rope to mount your draperies. Eye hooks and wall anchors can be used to secure one end of the wire to a nearby structure, post, beam or the exterior of your home.

Can you hang a curtain rod with a screwdriver?

A handheld screwdriver works well for the last few turns. Once you have your brackets attached to the wall, you’re ready to hang your curtain rod! It’s easiest to thread your curtains on the rod beforehand.

Do you need wall anchors for curtains?

You’ll need to use plastic wall anchors to provide proper support if you’re installing in drywall. Fasten the brackets to the walls using your drill or screwdriver. … Hang the curtains and double-check to make sure your brackets are still secure. Open and close to check that they’re functioning properly before finishing.

Will command strips hold a curtain pole?

Look no further than 3M Command hooks. Yes, the same hooks you use for hanging pictures, keys, mugs, and plants. An easy hack turns them into quick DIY supports for your curtain rod and that splash of color, sun shade, or bit of privacy you’ve been searching for.

Is it OK to put curtains over blinds?

We often get asked the question ‘do curtains and blinds work together? ‘ The answer is, for the most part, ‘yes‘ – when paired, the two can bring out a flexible décor and ensure adequate blocking of light and privacy control.

Can you put curtains over wood blinds?

1. Wood Blinds + Curtains. This combination of blinds with curtains is a classic for a reason: You absolutely cannot go wrong with wood blinds, or faux wood blinds, topped with curtains.

How do you hang curtains on a hollow wall?

1. Step 1: Mark the Spot for the Bracket. …
2. Step 2: Drill Top Hole. …
3. Step 3: Add Screw. …
4. Step 3: Insert a Molly Bolt Into the Hole. …
5. Step 3.5: Add Screw. …
6. Step 4: Dry Fit Bracket and Mark Second Hole Hole. …
7. Step 5: Drill Second Hole and Add Screw. …
8. Step 6: Repeat for Other Brackets.

Do curtain rods need to go into studs?

Well, you do NOT need a stud to hang a curtain rod, but you will need a special type of wall anchor to hold the weight. There are two different types I like to use: a drywall anchor or toggle bolts. … TIP: If you could have a stud in your wall, use a 1/8″ drill bit to check first. You will know if there is wood!

How do you support the center of a curtain rod?

If the curtain rod stands too far from the window for the pipe rail tie to work, you can make a support from a long, heavy-duty screw hook. Screw hooks are similar to eye hooks, which are heavy screws with a loop or ring at the end. Instead of a loop, screw hooks are shaped like a U or a C.